| Recent Answers |
 |
|
2008-05-10 Boat Repair - motor mount floor repair: you can remove or replace the mount but when you are done you have to realign the engine with the drive shaft of the sterndrive. first remove the stern drive...then work on the floor repair.. alignment...
|
2008-05-10 Boat Repair - OMC runs rough!: you should replace the condensor when replacing the points... and make sure they are gapped correctly. the sucking sound sounds like a carb problem..while running try to pin point where the air leak is...
|
2008-05-10 Boat Repair - tilt/trim wiring: First of all, the trim sensor is seperate from the trim motor wiring..one side of the gimbal housing where the drive connects to the boat is the trim indicator, the other side is the trim limit switch...
|
2008-05-10 Boat Repair - Steering Wheel: yes there is a special tool to remove it but here is how to do so without one..put the nut back on just so it is flush with the shaft, so you do not hurt the threads on it. then while you are pulling...
|
2008-05-09 Boat Repair - 1981 Johnson 150: when you saw the choke lever do you mean the warm up lever??? does it have a VRO if not check the fuel pump for leaks in the diaphram, if it has a hole if you remove it from the engine with th hoses in...
|