Although this is not my expertise here, I'll see if I can help. First check if you have voltage with the breaker on, at the lug the wire is connected too. If you have power there, then the problem is
It is the same coding, it is just alot harder to work with. Its your time, so it only matters to you. It is NOT exterior wiring, it is UNDER ground Feeder wire. UF Heavy rubber jacket I will assume
Connect 220 line black to P1. Connect line white to T4&T5. Insulate P2. Connect T2,3,8 together and insulate. This is for CW rotation. Depending on how the motor is mounted, you may have to reverse direction
Most of these motors are OEM. (Original Equipment Manufactured) These are made for a specific company, and are not available except from the pump manufacturer. I suggest you remove the motor and have a
If I can make sense out of this, your well pump is 220/240 volts. That means you do not need a neutral to run it...it also means you may NOT have a neutral in this location. If this is the case, you

©2012 About.com, a part of The New York Times Company. All rights reserved.