| Recent Answers |
 |
|
2008-06-28 fitting brakes: Ok do you know what type of brakes they have? I can't do much without knowing what they look like. As a basis there will be a bolt that goes into the cantilever that holds it to the brake boss, you need...
|
2008-06-22 Beginner Tricks: X-up's are a easy trick to start on just gradually turn the bars further each time you try it. A variation of this is barspin. Twists are another good one to learn for street riding. As you leave said...
|
2008-06-15 Sprocket: If you've already taken off the drive side then there will be a bolt on the back of the crank arm that you will need to undo if it's a 3 piece crankset. If not then undo the bolt that holds on the crank...
|
2008-06-02 help: There will be a bolt to tighten the brakes, pull the wire through this when the bolt is undone until the brake pads almost touch the wheel. Then using the screws on either side of the arms tighten the...
|
2008-05-29 bmxing: You want to look around the £300 mark if your learning as you will no doubt snap parts. The frame should be 4130 cromoloy steel instead of hi-tensile. Flatland is a difficult branch of bmx. You would need...
|
| More Answers for "BMX" |