| Name | Expertise | Status |
 |
Mike Wells
U.S.
View Profile
| PLEASE READ BEFORE ASKING A QUESTION!!! I CAN ONLY ANSWER QUESTIONS ABOUT HARLEYS !!! I DONT KNOW ANYTHING ABOUT OTHER MODELS!!! I have a Harley only shop with 30 years experience located in Ohio. We specialize in complete and total repair, restoration, hi-performance, and custom bike building. I can work on Flat Heads to Twin Cams. | Available
Ask A Question
View Past Answers |
Bill Silver
U.S.
View Profile
| Need help with vintage Hondas from the 1960s? I am an expert with 250-305cc bikes in particular and most all of the other pre-91 models, in general. I do NOT claim to have a great deal of experience on Gold Wings, Cruisers, ATC/ATVs and dirt bikes. | Maxed Out
View Past Answers |
Rich Johnston
U.S.
View Profile
| I have honda repair experience on all vintage Hondas from 1972 through 1980. I worked in a Honda dealership while going to college and have experience in all types of honda motorcyle repair. I don't have any experience on other brands. | Maxed Out
View Past Answers |
| |
| VOLUNTEER TO BE AN EXPERT IN THIS CATEGORY |
| Recent Answers |
|
|
2008-07-08 Honda Cb125s has no Spark: Abhimanyu, First thing to know is that these bike's ignition systems are battery-powered... 6volts. If you are thinking that it is a self-energizing magneto, you will waste more time and money. It needs...
|
2008-07-07 2001 Road King Classic, Sputtering/ Missing: I would start by checking the primary chain to make sure its not to tight or to loose. I dont think is clutch related, or it would do it at any RPM. Check also, to make sure you have a good fuel flow and...
|
2008-07-07 backfiring: SInce you have a carb, then its not fuel injected. Remove the carb and turn it over. Looking at the underside of the carb at teh back, behind the flaot bowl, you will see a round piece sticking up. Under...
|
2008-07-07 Checking stator and rotor: When you start the bike you should get around 13.5 volts at the battery. If not then do a OHMs test on the pins of the stator. Then do a OHMs test from one pin to ground and do the other. Your voltage...
|
2008-07-07 1966 XLCH: Get a service manual and it will show the wiring diagram and oil line routing. I cant tell you how bad it would be unless I inspected the wire. Since your bike is that old, I would buy a new wiring harness...
|
| More Answers for "Motorcycle Repair" |