You are here:

Chevrolet Repair/Experts

ExpertAverage RatingsExpertise

john turnipseed

U.S.
Available
any automotive repair questions , all makes and models

Robert Summers

Canada
On Vacation
returns 12/15/2009
domestic auto/truck repair, auto body, painting. I currently own a large auto/truck/marine repair shop. 40 years certified 310S,310T,310B in ontario Canada

Gary Malone

U.S.
On Vacation
returns 11/27/2009
any gm car truck and van

Recent Answers

2009-11-21 1997 Chevy Malibu 3.1 V6 . Water in the oil.:

The intake pushrods are marked with yellow stripes and are 5 3/4 inches long. Exhaust pushrods are marked with green stripes and are 6 inches long. The odds are that you did not damage the engine

2009-11-21 88 Chevy 1/2 ton...fuel pressure:

Yea , dont let you brother play with your truck. does the fuel pump run when it is in the truck ? you should be able to hear it run for a couple of seconds when you turn on the ignition. if the fuel

2009-11-21 1997 Chevy Malibu 3.1 V6 . Water in the oil.:

You should see nothing less than 100 psi. that being said , you need to install the new push rods to do a proper compression test. the intake gasket is very common on these engines , as is putting

2009-11-21 door handle bezel 1995 tahoe:

Remove or Disconnect Handle bezel from door trim panel. Insert a flat blade tool between the door inside bezel and the handle assembly. Carefully bend retaining clips outward while pulling out

2009-11-21 2003 cavalier buzzing/growling noise:

This is one of those cases where being there is the only way i would be likely to find the problem on this one. I have not seen this except when the wheel bearing/hub is going bad. you already fixed

All Answers

Answers by Expert:


Ask Experts

Volunteer


©2009 About.com, a part of The New York Times Company. All rights reserved.