You are here:

Mazda Repair/Experts

Expert	Average Ratings	Expertise
Mp2 U.S. Available View Profile Ask A Question View Past Answers	Knowledgeability 9.85 Clarity of Response 9.96 Timeliness 9.95 Politeness 9.96 Total Questions 1021	I prefer to answer questions relating to the Miata since this has been my area of specific expertise since 1991. I can answer questions relating to the other Mazda models however some limitation of expertise may reduce my accuracy.
joshua thorndyke Canada On Vacation returns 12/01/2009 View Profile View Past Answers	Knowledgeability 9.50 Clarity of Response 9.54 Timeliness 9.81 Politeness 9.71 Total Questions 509	i'm very helpful with the mazda 626/MX6 and also the ford probe i myself own a 1993 626 and have done alot of work to it. such as a motor,tranny removal/install. timing belt replacement, suspention, exhaust, whell bearing, interior and exterior panel removal/replacement, alternators, starters, distrubutors,and much more

Expert

Average Ratings

Expertise

Mp2

U.S.

Available

I prefer to answer questions relating to the Miata since this has been my area of specific expertise since 1991. I can answer questions relating to the other Mazda models however some limitation of expertise may reduce my accuracy.

joshua thorndyke

Canada

On Vacation
returns 12/01/2009

i'm very helpful with the mazda 626/MX6 and also the ford probe i myself own a 1993 626 and have done alot of work to it. such as a motor,tranny removal/install. timing belt replacement, suspention, exhaust, whell bearing, interior and exterior panel removal/replacement, alternators, starters, distrubutors,and much more

Volunteer to be an expert in this category

Recent Answers

2009-11-05 timing or blown engine:

What model Mazda? No oil is a killer and death comes fast when run dry on OHC engines. You'll have to perform a compression check to test your theory as a no oil situation can cause overlapping issues

2009-11-03 water pouring from what seems to be behind crank shaft pulley:

Right no crankshaft issue with 1991 and newer, sounds like someone was attempting to lead you astray again. By the description you give your front seal on the water pump has failed. This requires a new

2009-10-28 94 miata 1.8 125k mi:

You'll need more than just a head gasket for an overheat. You'll need to locate a good machine shop familiar with the Mazda OHC 4 valve to overhaul it, check clearances and machine as needed. As part

2009-10-26 Miata Engine/Clutch Replacement:

All 1.8 liter clutches are the same. A stage 1 ACT is $415, includes the disc, plate, TO bearing and pilot bearing and alignment tool. (about 20% heavier bite than stock, doubled centrifugal springs

2009-10-23 1990 Mazda Miata:

Buying used is always a gamble and since that control was only used from 1990-1993 it means anything used is pushing 20 years old. The ICS is available by itself through us for $484.19. One out of every

Answers by Expert:

Browse Answers: