You are here:

Roofing/Expert Profile

Steven C. Wadding RRC,RRO,CDT

U.S.

Available

Expertise

General questions in regards to most roof types and situations. As the Technical Services Manager for Polyglass USA, Inc. this would not be a forum to address any issues directly related to a product my employer manufacturers.

Experience in the area

I have been active in the roofing and waterproofing industries for more than 30 years with extensive experience from product installation, product development and consulting. I have been active in the Construction Specifications Institute and Roof Consultants Institute for approximately 20 years. I am a member of ASTM and am a voting member of various subcommittees. I have many years of consulting experience in the fields of Roofing, Waterproofing and Exterior Building Envelope disciplines.

Organizations

Roof Consultants Institute Construction Specifications Institute ASTM

Publications

Division 7 Technical Binders for Malarkey Roofing Products and Polyglass USA, Inc. CSI Phoenix Chapter Cactus Comments

Education/Credentials

Registered Roof Consultant - Roof Consultants Institute Registered Roof Observer - Roof Consultants Institute Certifified Document Technologist - Construction Specifications Institute Spray Fireproofing Special Inspector - International Code Council

Awards and Honors

Average Ratings

Recent Reviews from Users

User	Date	K	C	P	Comments
james	04/19/12	10	10	10	ok, thank you very much for your .....
joy	02/29/12	10	9	10	thanks for getting back with me regarding .....
Robert	11/30/11	10	10	10
Josh	10/25/11	10	10	10
Dave	10/10/11	7	6	7

Recent Answers from Steven C. Wadding RRC,RRO,CDT

2012-04-18 insulation:

James, The wording of your questions leaves me with a couple questions, so in anwering I will make a few presumptions as follows; 1) Roof is a steeper slope type roof, Slope is equal to or greater

2012-02-27 choice of new roof with hard insulation in the attic:

Joy, The use of Polyurethane and similar spray-applied insulations directly to the underside of the roof deck is a recent practice within the building industry. Most roofing products manufacturer's

2012-01-28 is my contractor wrong?:

Good Morning Scott, The only legitimate reason the Building Inspector can "fail" the roof install would be it was not complaint with the jurisdictional Building Code. To my knowledge all of Colorado

2012-01-21 hole in my rubber roof:

Bob, Sorry for the delay in responding. Your question states that your roof is "rubber" which can often be used generically and misunderstood. The only "rubber" roof that is truly rubber is EPDM, with

2012-01-08 waterproofing for masonry wall with plaster:

Owen, There are unknowns related to the CMU block wall configuration. For the sake of answering your question, I will presume that; 1) this is a single family residential structure, 2) all portions

Roofing

Answers by Expert:

Browse Answers: