| Recent Answers from Willie Cutit |
 |
2008-06-08 interbal boring bars: Gary, After reading your question, I understand it to be that you need to relieve an ID bore from 1 in to an arc depth of 1.940” A multi directional tool with a full radius would accomplish this...
|
2008-03-05 custom 465: Darryl, It's tough to give you a black and white answer to milling questions as there are so many variables to deal with. You gave me the RPMS and IPM but not the diameter of the cutter, pitch of the...
|
2008-02-16 diamond tip drill bit for hard steel: Hey Jim, Good morning I would not use a Diamond bit to drill that out. Is there any way you could take a punch set and tap it out with WD40? If not, get a carbide drill. This will drill it out...
|
2007-10-06 About cutting tools: Good day to you...I have a project about topics in cutting tools..I've been researching in the internet but i can't find any website about machines or cutting tools...that's why i need the help of an expert...
|
2007-02-10 cutting tool: Hey Joe, Good question. Endmills: Make sure the endmill is not damaged along the cutting edge. The number of regrinds will be dictated by the chip evaluation of the flute and material you will...
|
| More Answers for "Machine Tools" |