Ed Kerr - Welding - Construction Industry - Industry

About > AllExperts
	Search for

Main Menu

Login (Experts Only)

About Us · FAQ · Tell Friends About Us · Link To Us · Free Encyclopedia · Disclaimer · Tech Support

You are here: AllExperts > Industry > Construction Industry > Welding

Expert Profile: Ed Kerr

Expertise: I can answer questions about TIG,MIG and Stick welding, Oxy fuel and Plasma cutting. The affects welding and heat have on certain metals. Materials you can and cannot weld. What to do and not to do on pressure vessel and pipe repairs.

Experience in the area
22 years Aviation and aerospace tooling and equipment fabrication, welding and repair. Aircraft airframe welding and repair. Welding exotic metals and alloys.Marine Aluminum and Stainless steel welding and fabrication. General welding and fabrication.

Education/Credentials
H.S diploma

Awards and Honors
American Welding Society Welding code certifications Military Spec welding procedures and qualifications

Ask a Question	View Past Answers	View Ratings

Average Ratings
Prestige Points: 620
Knowledge	9.55 Best of the best
Clarity of Response	9.55 Best of the best
Timeliness	9.95 Best of the best
Politeness	9.80 Best of the best
Number Of Questions (in Past 24 Hours)		0
Max Questions to be Asked (in 24 Hour period)		5
Total Questions (since joining AllExperts)		56

Recent Reviews from Users

Knowl	Clarity	Time	Politeness	Date
10	10	10	10	09/15/08
10	10	10	10	09/10/08
10	10	10	10	08/28/08
10	10	10	10	08/26/08
10	10	10	10	08/22/08

User Comments

thank you for the advice i will try it
(Ricky on 09/15/08)

thanks ill take a look at the requirements for my state
(sean walker on 09/10/08)

Thank you sir for helping me out with this information. Your the only one that replied back, sorry about the misspelled words.
(asa on 08/26/08)

The answer was right on time, took care of the problem and we were able to get the job going. thanks for the great help.
(donnie cain on 08/22/08)

View All Comments

Ask a Question	View Past Answers	View Ratings

Recent Answers from Ed Kerr

2008-09-08 repairing a baseball sized hole in 36" crude oil pipeline: Hi, This repair sounds like it will take place in an oil refinery or platform. As far as permits go, I'm not sure which agency,(county,state,Code) would require you to have a permit. I'm sure you would...

2008-09-07 pipeline welding: Hi, Pipeline welding, specifically pipeline code welding, has for the most part been using the SMAW (stick welding) process. Primarily because it is the oldest process, also, as far as equipment and consumables...

2008-08-26 plate and post welding: Hi, To satisfy a welding inspector, you will need an engineer to provide you with a welding procedure specific to the welding job you have here. Did your customer not give you any drawings or documentation...

2008-08-25 mig welding: Hi, Typically you have just a single root pass. With MIG welding, you have to be careful not to over heat the part, so take the time between passes to brush and if needed, some grinding. Since I don't...

2008-08-25 welding,cutting and flashburns: Hi, If I were you I'd go to Amazon.com and find a couple of books on welding and cutting. It would take me about a week of steady typing just to explain welding and cutting basics. As far as flash burn(Welders...